Scrapbooking - Picture Holder Tag

Materials:

• Manilla tag Size 5
• Mary Engelbreit Floral Sticker Sheet
• White Vellum (gold or silver would also be nice!)
• Sew Sweet Strings

Instructions:

- Wet Manilla tag with water. Crumple into a ball (be careful not to tear it). Flatten out to dry. To dry it quickly iron it with a warm iron (stays flatter if ironed). This gives it a weathered/handmade look. You can do this with cardstock too.
- You can lightly chalk the tag with brown to further age it.
- Cut a piece of vellum the width or your tag & about 2" high. Tear 1/4 - 1/4" off top edge.
- Glue vellum piece on tag along side & bottom edges.
- Apply sticker borders to bottom & edges. To get perfect corners lay side border over bottom border (on the tag) & cut corner at an angle before sticking them down firmly. Take off cut edges & corners should fit perfectly.
- Apply a few stickers along bottom edge randomly. Then apply a few more with peel 'n stick foam square on the back to give the bottom a 3D look.
- Tie ribbon or fibers to top of tag. To tie fold ribbon in half & slide through hole. Slide rest of ribbon through loop & tighten.
- Put a picture in the vellum pocket.

Use to display pictures on your fridge, as a gift tag or on a scrapbook page.